thumbnail

How to connect TV to HD cablebox and DVD wirelessly from other rooms!


read more

Actiontec MywirelessTV2 comes with 2 boxes and hdmi cables, Transmits hdmi signal up to 150ft to any room in your home! Perfect for mirror hd cablebox to garage or back patio tv wirelessly. get it here- http://amzn.to/176ffP8
 
thumbnail

Akai tv lct3201ad Dead no power repair fix!


read more
Akai tv repair lct3201ad Dead no power fix!
Solution below
location #      /    PARTS
ec14 and ec25, all 470mf 35v capacitors
ec18, ec19, ec20, all 1000mf 16v caps
caps may look ok but tested bad.

thumbnail

How to test ICs for plasma TV Y-buffer boards


read more
How to test ICs for plasma TV Y-buffer boards link here- Y buffer ICs and boards or Y buffer ICs diagram

thumbnail

2 ways to test bridge rectifiers & checking standby volts on power board


read more

2 ways to test bridge rectifiers & checking standby volts on power board, standby volts can be either 5v or 3.3 dc volts even with tv off. bridge rectifiers read .4 to.7 is ok in diode mode on meter.





thumbnail

Common Fixes for Sony bravia TVs KDL XBR- Red light blinking CODES!


read more


to reset sony TV 1st unplug all cables from tv and power for 5 minutes but if that reset fails then next is to factory reset by holding TV Remote's "UP" on directional pad while pressing "power" ON THE TV.


Red led light blinks flashes, red light error code troubleshooting Chart,

2 red flashes is bad power board

3 red flashes is bad main or power board

5 red flashes is bad lcd panel connection or internal lcd short- expensive fix

6 red flashes is backlight error check bad main board, power board or inverter boards- unplug one by one to see if tv stays on

7 red flashes is main board over heating

8 red flashes is main board sp prot

11 red flashes is trident IC, bad main board

12 red light flashes is tcon error bad T-con board or bad LCD panel (tv turns off after a minute)

13 red flashing is backlight balance error bad lcd panel or inverter boards (common) or balancer boards on kdl-52v4100 only

14 red flashes is HFR error bad TCON or Bad LCD panel, in this video its bad T-con board.

"how to download update"

Download UPDATES KDL-52W4100 & KDL-52V4100

Sony kdl-52w4100 usb update - http://esupport.sony.com/US/p/model-home.pl?mdl=KDL52W4100&template_id=1&region_id=1&tab=download#/downloadTab

Sony KDL-52v4100 http://esupport.sony.com/US/p/model-home.pl?mdl=KDL52V4100&template_id=1&region_id=1&tab=download#/downloadTab
thumbnail

How to fix Plasma TV no picture or clicking on off


read more

How to fix Samsung Plasma TV no picture or clicking noise. Y sustain main board repair kit! Samsung BN96-06086A Y-Main Board Component Repair Kit.

clicking on off can be from few swollen capacitors in power board but sometimes ICs on y buffer boards short and transistors on y main sustain board can go bad time to time so here's a link to fix that issue. Y sustain board repair kit to fix clicking or no tv picture issues.

thumbnail

Common DLP TV repair for Toshiba, Samsung HL, Mitsubishi WD models


read more
Common fix for DLP TVs Samsung HL, Mitsubishi WD, Toshiba 57HM167, 65HM167 is DLP chip.
Free Samsung TV fix by repair warranty service tech for DLP models HL-P, HL-R, HL-S, HL-T, see link below. In most DLP TVs the lamp goes out first then sometimes capacitors in power board swell up and color wheel goes bad. Also DLP chip in light engine may go bad time to time, sometimes these parts are covered by extended warranty just go to TV brand website. If you have no picture or dots, shadows on screen then suspect it is bad DLP chip. if TV does not turn on it can be bad power board or main logic board. if the DLP light bulb (dlp lamp) in the back vent is NOT lighting up then DLP lamp is bad, just order a lamp for your tv model and install it by opening the small door on the back panel (lamp just slides out & in) .
http://www.samsung.com/us/dlptvsettlement/

thumbnail

How to fix Westinghouse LCD TV EW40T4FW, B12083895 Board repair


read more
How to fix Westinghouse LCD TV

EW40T4FW, B12083895 Board UF11 repair. EEprom IC chip will fix most no power Westinghouse EW40T4FW TVs. Bad part location on main video board is UF11 (green board).
First unplug TV. EEprom can be removed by 30watt solder iron and desoldering wire but don't over heat board. use tweezers to slowly pull out eeprom. when working on TVs work in a static free area like a garage (off rugs and carpet) . i recommend using thin rubber gloves try to hold eeprom's body, don't touch the pins. put new eeprom in by lining up the circle depression in corner of eeprom to the marker dot or stripe on the board. Next solder the pins to board (don't over heat pins on eeprom or board) soldering each pin should only take 1-2 seconds for each pin. Double check your work, make sure solder didn't overflow and solder 2 pins together. Now test your TV. Let us know if it fixes your TV. Share this blog if it does, thanks.

thumbnail

How to repair / fix Panasonic tv TC-50PU54, TC-P50U50, TC-P50UT50


read more
How to repair / fix Panasonic tv TC-50PU54, TC-P50U50, TC-P50UT50,

Panasonic TXNSS1SDUU (TNPA5623) SS Board Component Repair Kit. 


thumbnail

How to fix / repair Panasonic tv TH-58PZ800B, TH-58PZ800U, TH-58PZ850U


read more
How to fix / repair Panasonic tv TH-58PZ800B, TH-58PZ800U, TH-58PZ850U
This repair kit will fix your tv power board.


thumbnail

COMMON LCD TV SERVICE REPAIR PICTURE SCREEN COLORS FIXED


read more


common TV service repair for sony & samsung that have lines in screen, no picture, discolored or distorted video is tcon board.
 
thumbnail

WHAT Plasma TV BOARD CAUSES NO PICTURE REVIEW


read more
Y-Main Board YSUS Y-Sustain PBA Number: LJ92-01601A PCB Number: LJ41-05905A TV Panel Model: S50HW-YD11 | S50HW-YB04 i suggest getting repair kit, service manual, or just get the y board listed below. y sustain and y buffer boards time to time go bad, capacitors & transistors on heatsink sometimes go bad too. (ymain sustain board and buffer boards displays "scans" the image on tv screen)
 
 
thumbnail

HOWTO TROUBLESHOOT LCD TV REPAIR SERVICE GUIDE DIAGRAM


read more
HOWTO TROUBLESHOOT LCD TV REPAIR SERVICE GUIDE DIAGRAM

thumbnail

Common bad tv parts are capacitors in LCD & Plasma TVs, more info here!


read more

most commonly replaced tv capacitors are 
100uf, 1000uf, 2200uf & 3300uf 16v or 25v
thumbnail

Easy Most Common Repairs for LCD, LED, Plasma, Dlp, Projectors!!!


read more
Easy Most Common Repairs for LCD, LED, Plasma, Dlp, Projectors!!!
thumbnail

Easy LCD repair, How to Fix Sony TV dead no red light blinking


read more
thumbnail

Easy Ways to FIX TV Snowy Static Picture Screen (+playlist)


read more
thumbnail

Easy Common Sony TV repair service review


read more
Easy Common Sony XBR TV repair service review NO POWER TURN ON THEN OFF 2 RED LED BLINKING LIGHT NOT WORKING BROKEN BRAVIA LCD